Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CCM 4.1 Route List Failure

Hi, I am after modifying my set up for the remote locations. I have over 50 sites, each has its own gateway and have very few handsets per site. Currently I am using an H323 Gateways with 4 ISDN channels. However I wish to change it to save money by reducing the remote gateways having 2 channels and any further outgoing calls over 2 to go across the WAN to break out through the Head Office Gateway which has more than enough channels (also an H323 gateway).

However when setting up the 2 route groups (one for local gateway and the other for HQ gateways)the calls fail if I disable the ISDN channels on the local gateway.

However when routing calls from the remote location direct to the HQ gateways then the calls go through succesfully.

Hope I have explained myself well and someone could help?

Darren.

2 REPLIES

Re: CCM 4.1 Route List Failure

Hi,

How are you disabling the channels and where are you disabling it?

Regards

Sam Wilson

Community Member

Re: CCM 4.1 Route List Failure

Sam,

I am disabling the channels on the ISDN gateway interfaces by issueing the shut command on interfaces BRI2/0 and 2/1.

Regards,

Darren.

94
Views
0
Helpful
2
Replies
CreatePlease to create content