I have a Unified Call Manager 4.2 based VOIP network and a Call Center project based on this. I bought a 0800 number for incoming call to the CC. That 0800 number is just a virtual number, the calls from that number are entering my system trough a 'normal' number like 021406xxxx. I need to forward that number(021406xxxx) to a routing point. That number is not attached to any phone. I tryed to make a hunt group but I cannot use RP's into the group, I can only use the configured DN's from the system. How can I forward that number to the RP?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...