just recieved (2) new ibm 7835-I2 servers running callmanager 5.1.1 and when I start them up they stop at the "Welcome to Cisco Unified CallManager 184.108.40.20600-5" prompt. Has anyone experienced this before? Your input would be appreciated.
try to boot up from ur shipped CCM 5.1 DVD's (Cisco Callmanager installation DVD) that came with ur CCM, go in setup process and when asked whether replace existing CCM image on ur 7935 with the new image (on the DVD) say yes...
actually u will find the version on ur DVD is the same version of the preinstalled one.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.