I´ve a CCM cluster 188.8.131.520-12, and I´m tryng to enable a trunk SIP against a Asterisk SIP Server which provides an access to cell phone calls. But the CCM is not able to reach the Asterisk. I can ping the server ok, but if a IP phone tries to call using the trunk SIP I receive congestion tone,but on Asterisk no sip invite (or any sip activity is received).
But the Asterisk can call IP phones registered on CCM, so the issue is not on the LAN. Also I´ve tested using a gateway on the same lan as CCM cluster, and with a csim start on gateway I can call cell phones using the Asterisk.
Also I have tested using a free sip softphone on the same LAN as IP phones, and with the softphone I can also call using the asterisk.
According to all this, the issue is on the CCM cluster, maybe there is something missing on the config, or maybe there is a bug for this version of CCM.
No. We have 2 LANs: LAN A is were is placed the CCM, IP Phones, gateway and the mentioned SIP softphone. LAN B is were is placed the Asterisk.
The sip softphone can register to the asterisk and make calls without problems. That config was just to test that SIP packets can go from LAN A to LAN B.
2.- Have you checked the Security profile on SIP Trunk and verify it matches the protocol (TCP/UDP or TLS) just enabled default parameters in SIP Profileand test?
Security profile is on "Non secure SIP trunk profile", there is no security enable on this cluster, so every phone and gateway has non secure profiles.
3.- This is basic function, make sure your CSS, SIP trunk profile and IP address is correct
IP address is correct, from gateway on LAN A I´ve made a sip dial peer pointing to that IP address and using a csim start I could check a correct call. SIP Profile is standard, should I modify something on it? Css has full access to everywhere.
4.- Check codec matches b/w CUCM SIP trunk and *
With the mentioned dial-peer I´ve checked that using g711 I can make a call from LAN A to Asterisk. But it seems that the CCM is not sending anything to asterisk, because on asterisk no sip packet is received. I´ll put a gateway on LAN B just to debug if something is received from the CCM.
5.- If still no luck please upload CCM SDI/SDL and include calling called number and timestamps and I can take a look
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...