Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCM 6 H323 GW ISDN E1 issue

Hi,

I use Callmanager 6.0 with Cisco2801 gw and terminate an 8-channel E1. We can receive calls from PSTN. However we can not make calls to outside ISDN cause code 44 requested/circuit/channel not available. Also the other end rings once and it stops. So people can see that who has called but the call can not be established. I upgraded the router to latest IOS. Please have a look and comment.

Regrds,

Yigit

3 REPLIES

Re: CCM 6 H323 GW ISDN E1 issue

Yigit:

Looking at your H323GW config, i see two things are missing

1. Line code and framing are missing from the controller configuration

2. There are no outbound dial-peers configured.

Also can you try "sh isdn status" and see if connection with PSTN has been established?

New Member

Re: CCM 6 H323 GW ISDN E1 issue

Hi,

Linecode and framing does not appear in the config because they are in their default values. As I stated when a call generated from IP Phone, PSTN phone rings once so sh isdn status shows Multiple frame established. I suspect that it is something to do with ISDN negotiations. There is one pots one voip dial peers and if there would be a missing dial peer it couldn't hit the E1 port.

Regards,

Yigit

Hall of Fame Super Gold

Re: CCM 6 H323 GW ISDN E1 issue

Hi, all is good in your Q931 setup. Contact telco, report the problem, the only unlikely possibility is that they want something different than unknown/unknown for type/plan.

130
Views
0
Helpful
3
Replies
CreatePlease login to create content