Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCM 7.x and VG224 Device Setup

When configuring a device on a CCM 7.x and VG224, do you have telnet to to the VG as you wold in a VG248 or it it all done through the admin portion of the CCM via Device > Gateway?

I have built a user and when plugged in, their is dial tone, but noting happens when dialing from that port.

Am I missing something?

3 REPLIES
Super Bronze

Re: CCM 7.x and VG224 Device Setup

Hi

Yes, it's an IOS gateway.

You configure it like you would an ISR - go in and do the SCCP or MGCP config from the box in conjunction with the CCM side stuff.

Regards

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
New Member

Re: CCM 7.x and VG224 Device Setup

The devise is already setup, it is adding users/ports that is the issue.

Re: CCM 7.x and VG224 Device Setup

If you're doing SCCP (keyword in IOS is "stcapp"), you configure the stations as SCCP devices similar to phones.

If you're doing MGCP on the gateway, you configure the ports within the gateway configuration page on a port-by-port basis.

Hailey


Please rate helpful posts!

284
Views
0
Helpful
3
Replies