Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CCM confernce:using 2 device pool

Hello,

I'm using CCM6 with a Voip call.

The VoIP Call use G729 codec.

The internal call use G711.

I use a IOS MTP with G729 Codec.

If I use the Default DevicePool,

I cannot call through the VoIP.

So I've created a new Device pool that use another region with G729 COdec. and I can call with the VoIP.

Now all work fine, but only the conference with the Voip Call is now blocked.

Is it possible to communicate the 2 device pool? The first use g711 and the other use g729.

Is IOS Conference bridge can be a solution?

thks

3 REPLIES
Hall of Fame Super Red

Re: CCM confernce:using 2 device pool

Hi Solo,

You are right on the money my friend :) You are seeing this restriction that applies to Software Conference Bridges;

This really sounds like a Codec issue. Have a look;

Cisco CallManager Software Conference Bridge supports only G.711 a-law and G.711 u-law and does not understand any other codec such as G.729.

From this Conferencing doc;

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a008009476a.shtml

Hope this helps!

Rob

New Member

Re: CCM confernce:using 2 device pool

Yes I want a codec issue,

And now I cannot configure the MTP.

My Router have 2 PVDM2-64 and two Ethernet interfaces.

I've put the first interface for MTP, and the sercond for transcoder.

The MTP can be registered but the second (Transcoder) is Rejected.

Have you any issues?

This is the configuration :

=======================================

sccp local GigabitEthernet0/1

sccp ccm 192.168.20.3 identifier 2 version 5.0.1

sccp ccm 192.168.20.2 identifier 1 version 5.0.1

sccp ip precedence 3

sccp

!

sccp ccm group 1

bind interface GigabitEthernet0/1

associate ccm 1 priority 1

associate profile 111 register TXC001CF6FB1E00

associate profile 1 register MTP001CF6FB1E01

!

dspfarm profile 111 transcode

description transcode profile 111

codec g711ulaw

codec g711alaw

codec g729ar8

codec g729abr8

codec gsmfr

codec g729r8

maximum sessions 4

associate application SCCP

!

dspfarm profile 1 mtp

description Software MTP

codec pass-through

codec g729r8

maximum sessions software 400

associate application SCCP

!

=======================================

I'm Trying this :

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a008084fe1f.shtml

New Member

Re: CCM confernce:using 2 device pool

Hi,

I've configured 2 device pool, the VoIP call cannot be established if i use the DevicePool for all ipphones and servers.

The first Device pool is configured with region with g711 codec, and the second for the VoIP is configured with g729.

They're based on the region, and i'm not good with regions.

Any issues?

139
Views
4
Helpful
3
Replies
CreatePlease to create content