I have an IAD2431-8FXS and while trying to add it to my UCM 6.1 server I find that the ccm-manager command is not recognized. I have a few IAD2421-16FXS routers configured with UCM 6.1 running MGCP and I was under the impression all of the IAD2400 series gateways would work. I noticed under the specs on the IAD2431 that UCM was not listed under supported call agents. I know this is a lame questions, but am I unable to connect this to my call manager.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...