A remote cm at a branch is able to receive calls, but cannot call out. All outbound calls get a busy tone. Strange thing, The same cm has a fxs card with two analog phones attached. These phone are able to receive calls,but cannot make out going calls as well!!
Cisco 2801 (revision 7.0) with 235520K/26624K bytes of memory. Processor board ID FTX1208W0KF 2 FastEthernet interfaces 1 terminal line 4 Voice FXS interfaces 1 DSP, 8 Voice resources 1 cisco service engine(s) DRAM configuration is 64 bits wide with parity disabled. 191K bytes of NVRAM. 126976K bytes of ATA CompactFlash (Read/Write)
1 -rw- 27944864 Feb 20 2008 14:20:02 -08:00 c2801-spservicesk9-mz.124-9.T7.bin 2 -rw- 1821 Feb 20 2008 14:40:52 -08:00 sdmconfig-2801.cfg 3 -rw- 6036480 Feb 20 2008 14:41:32 -08:00 sdm.tar 4 -rw- 861696 Feb 20 2008 14:41:52 -08:00 es.tar 5 -rw- 1164288 Feb 20 2008 14:42:16 -08:00 common.tar 6 -rw- 1038 Feb 20 2008 14:42:38 -08:00 home.shtml 7 -rw- 113152 Feb 20 2008 14:42:56 -08:00 home.tar 8 -rw- 1697952 Feb 20 2008 14:43:30 -08:00 securedesktop-ios-22.214.171.124-k9.pkg 9 -rw- 416354 Feb 20 2008 14:43:56 -08:00 sslclient-win-126.96.36.199.pkg 10 -rw- 214561 Feb 23 2010 08:47:16 -08:00 crashinfo_20100223-164717
129748992 bytes total (91275264 bytes free)
boot-start-marker boot-end-marker ! logging buffered 51200 warnings enable secret 5 $1$VKuA$bDZPvyGGc0S01DVm.g7LO. ! no aaa new-model ! resource policy ! memory-size iomem 10 clock timezone PST -8 clock summer-time PDT recurring ip cef ! ! no ip dhcp use vrf connected
voice-card 0 dsp services dspfarm ! ! voice rtp send-recv ! voice service voip allow-connections h323 to h323 allow-connections h323 to sip allow-connections sip to h323 allow-connections sip to sip no supplementary-service h450.2 no supplementary-service h450.3 h323 no telephony-service ccm-compatible sip rel1xx disable no call service stop ! ! voice class codec 1 codec preference 1 g729r8 !
! dial-control-mib retain-timer 30
! interface FastEthernet0/0 description Default VLAN ip address 10.x.x.2 255.255.255.0 ip nbar protocol-discovery duplex auto speed auto ! interface Service-Engine0/1 ip unnumbered FastEthernet0/0 ip nbar protocol-discovery service-module ip address 10.x.x.3 255.255.255.0 service-module ip default-gateway 10.x.x.1 ! interface FastEthernet0/1 ip address dhcp shutdown duplex auto speed auto ! ip route 0.0.0.0 0.0.0.0 10.x.x.1 ip route 10.x.x.3 255.255.255.255 Service-Engine0/1 ! ! ip http server ip http authentication local no ip http secure-server ip http timeout-policy idle 60 life 86400 requests 10000 ip http path flash: !
tftp-server flash:CP7905080001SCCP051117A.sbin tftp-server flash:CP7912080001SCCP051117A.sbin ! control-plane ! ! ! voice-port 0/0/0 echo-cancel coverage 32 ! voice-port 0/0/1 echo-cancel coverage 32 ! voice-port 0/0/2 echo-cancel coverage 32 ! voice-port 0/0/3 ! ! ! sccp local FastEthernet0/0 sccp ccm 10.x.x.2 identifier 10 sccp ! sccp ccm group 999 associate ccm 10 priority 1 associate profile 1 register mtp123456792012 keepalive retries 5 switchover method immediate switchback method immediate switchback interval 5 ! dspfarm profile 1 transcode codec g711ulaw codec g711alaw codec g729ar8 codec g729abr8 codec g729r8 maximum sessions 3 associate application SCCP ! dial-peer cor custom name 1800 name 1866 name 1877 name LocalCall name 1888 name no-restrict name Operator ! ! dial-peer cor list Toll-Restrict member 1800 member 1866 member 1877 member LocalCall member 1888 member Operator ! dial-peer cor list Call1800 member 1800 ! dial-peer cor list Call1866 member 1866 ! dial-peer cor list Call1877 member 1877 ! dial-peer cor list CallLocal member LocalCall ! dial-peer cor list Call1888 member 1888 ! dial-peer cor list no-restriction member no-restrict ! dial-peer cor list CallOperator member Operator ! ! dial-peer voice 200 voip corlist outgoing no-restriction description CalPri max-conn 8 destination-pattern .T session target ipv4:10.x.x.x dtmf-relay cisco-rtp playout-delay nominal 250 playout-delay mode fixed fax rate 7200 ip qos dscp cs5 media no vad ! dial-peer voice 201 voip corlist outgoing Call1800 huntstop max-conn 3 destination-pattern 1800.......T session target ipv4:10.x.x.x dtmf-relay h245-alphanumeric playout-delay nominal 200 playout-delay mode fixed fax rate 7200 ip qos dscp cs5 media no vad ! dial-peer voice 100 pots huntstop destination-pattern xxxxxxx port 0/0/0 ! dial-peer voice 103 pots huntstop destination-pattern xxxxxx port 0/0/2 ! dial-peer voice 301 voip corlist outgoing Call1800 destination-pattern 1800.......T session target ipv4:10.x.x.x dtmf-relay h245-alphanumeric ! dial-peer voice 302 voip corlist outgoing Call1866 destination-pattern 1866.......T session target ipv4:10.x.x.x dtmf-relay h245-alphanumeric ! dial-peer voice 303 voip corlist outgoing Call1877 destination-pattern 1877.......T session target ipv4:x.x.x.x dtmf-relay h245-alphanumeric ! dial-peer voice 304 voip corlist outgoing CallLocal destination-pattern [2-9]......T session target ipv4:x.x.x.x dtmf-relay h245-alphanumeric ! dial-peer voice 305 voip corlist outgoing Call1888 destination-pattern 1888.......T session target ipv4:10.x.x.x dtmf-relay h245-alphanumeric ! dial-peer voice 2000 voip destination-pattern 2000 session protocol sipv2 session target ipv4:10.x.x.x dtmf-relay sip-notify codec g711ulaw no vad ! dial-peer voice 202 voip corlist outgoing Call1866 destination-pattern 1866.......T session target ipv4:10.x.x.x dtmf-relay h245-alphanumeric ! dial-peer voice 203 voip corlist outgoing Call1877 destination-pattern 1877.......T session target ipv4:10.x.x.x dtmf-relay h245-alphanumeric ! dial-peer voice 204 voip corlist outgoing CallLocal destination-pattern [2-9]......T session target ipv4:10.x.x.x dtmf-relay h245-alphanumeric ! dial-peer voice 306 voip corlist outgoing CallOperator destination-pattern 0$ session target ipv4:x.x.x.x dtmf-relay h245-alphanumeric ! ! telephony-service load 7912 CP7912060000SCCP050124A max-ephones 24 max-dn 120 ip source-address 10.x.x.xport 2000 timeouts interdigit 3 system message xxxxx sdspfarm units 2 sdspfarm transcode sessions 2 sdspfarm tag 1 mtp123456792012 voicemail 2000 max-conferences 0 gain -6 call-forward pattern .T dn-webedit time-webedit transfer-system full-blind transfer-pattern .T create cnf-files version-stamp 7960 Feb 23 2010 09:08:04 ! ! ephone-dn 4 number xxx call-forward busy 2000 call-forward noan 2000 timeout 20 ! ! ephone-dn 5 number xxxx call-forward all xxx call-forward busy 2000 call-forward noan 2000 timeout 20 ! ! ephone-dn 110 number 8001.......... mwi off ! ! ephone-dn 111 number 8000.......... mwi on ! ! ephone 1 mac-address 0014.1C48.D665 ! ! ! ephone 2 mac-address 001D.4595.C4DD ! ! ! ephone 3 mac-address 001D.4595.C476 ! ! ephone 4 mac-address 001D.4595.9959 button 1:4 ! ! ! ephone 5 mac-address 001D.A23E.DA3B type 7912 button 1:5 ! ! ! ephone 7 mac-address 001D.4595.C507 ! ! ! ephone 8 mac-address 001A.2FBE.A124 !
I had a look at the config and am abit confused.You don't seem to have any local breakout, could you explain in more detail how calls should come in and go out of the Callmanager or is it Callmanager Express?
It is the IP address of our PRI wich is connected to the PSTN!! There is full IP connectivity between remote CME router and the PRI router; therefore, the session target of the outbound interface is NOT THE ISSUE.
The PRI configuration is fine as well as well as we have other remote conntected to the same with no issue. And the remote that we are hing issue with was working up to last Sunday. We have taken the config of the remote, changed the IP at both side(PRI and test router), added it to a test router in our HQ. Everything works fine. This test told us that the remote router is faulty, but how come it still receive calls?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...