I currently have two completely hardware seperate phone systems, both running cisco ccm 4.2(3) with a publisher & subscriber server, the "New" phone system I built was completely created from scratch, due to many techincal and hardware reasons.
For my PRI gateways I run 6608 (use 2 of 8 t1 as PRI),
The issue is this: when im on my old(existing) phone system, I'm able to ping the PRI interface port without any problem.
But, when I did a test run of my new ccm system after hours, my new CCM could no longer ping the PRI ports. Only configuration adjustment made was this.
Original config line:
set port voice interface 4/7 dhcp disable 10.10.10.20 255.255.255.0 vlan 65 tftp 10.10.10.15 gateway 10.10.10.1
New config line:
set port voice interface 4/7 dhcp disable 10.10.10.20 255.255.255.0 vlan 65 tftp 10.10.10.96 gateway 10.10.10.1
Any advice on how to go about troublshooting this?
I would suggest even trying to disable the port and enable it back to see if you are able to get them registered. Also 6608 modules sometimes need a reset of the module (reset 5, where 6608 is in slot 5).
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.