I have a basic setup question. I am a newbe when it comes to this part of CCM configs. I am setting up a single CCM and Unity system that will service 4 remote sites connected by WAN. Each site will have its own PSTN GW configured in CM
My goal is as follows,
1. All phones should be able to 4 digit dial all other phones at other sites internally
2. At each site when an off net call is placed, it will route out the sites local PSTN GW.
What would be the best way to accomplish this and give me the ability to add sites in the future?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...