Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CCM upgrade from 6.1 to 8.6

Dear All,

we  have CUCM System version: 6.1.2.1000-13 running on MCS7825I3-K9-CMB2 and we are planning to upgrade it to 8.6 , do i need to change my hardware or not ?

please advise.

2 ACCEPTED SOLUTIONS

Accepted Solutions

CCM upgrade from 6.1 to 8.6

Hi Muzzamil.

This link should help you

http://www.cisco.com/en/US/prod/collateral/voicesw/ps6790/ps5748/ps378/prod_brochure0900aecd8062a4f9.html

HTH

Regards

Carlo

Please rate all helpful posts "The more you help the more you learn"
Cisco Employee

CCM upgrade from 6.1 to 8.6

Yes, it is Supported, but note that Cisco Unified Communications Manager 5.0 and later require or recommend (depending on server model and software release) minimum memory and disk size as described in the table below. For Cisco Unified Communications Manager 8.0(3) and above, it is strongly recommended to upgrade to minimum 4GB RAM and 146GB disk drive; whether this is necessary for your deployment is design-dependent and depends on call volume, installed locales, dial plans, phone firmware loads, music files, etc. Use

http://www.cisco.com/go/swonly to get supported memory and disk part numbers. Supported, but note that Cisco Unified Communications Manager 5.0 and later require or recommend (depending on server model and software release) minimum memory and disk size as described in the table below. For Cisco Unified Communications Manager 8.0(3) and above, it is strongly recommended to upgrade to minimum 4GB RAM and 146GB disk drive; whether this is necessary for your deployment is design-dependent and depends on call volume, installed locales, dial plans, phone firmware loads, music files, etc. Use http://www.cisco.com/go/swonly to get supported memory and disk part numbers.

Please rate helpful posts.


GP.

3 REPLIES

CCM upgrade from 6.1 to 8.6

Hi Muzzamil.

This link should help you

http://www.cisco.com/en/US/prod/collateral/voicesw/ps6790/ps5748/ps378/prod_brochure0900aecd8062a4f9.html

HTH

Regards

Carlo

Please rate all helpful posts "The more you help the more you learn"
Cisco Employee

CCM upgrade from 6.1 to 8.6

Yes, it is Supported, but note that Cisco Unified Communications Manager 5.0 and later require or recommend (depending on server model and software release) minimum memory and disk size as described in the table below. For Cisco Unified Communications Manager 8.0(3) and above, it is strongly recommended to upgrade to minimum 4GB RAM and 146GB disk drive; whether this is necessary for your deployment is design-dependent and depends on call volume, installed locales, dial plans, phone firmware loads, music files, etc. Use

http://www.cisco.com/go/swonly to get supported memory and disk part numbers. Supported, but note that Cisco Unified Communications Manager 5.0 and later require or recommend (depending on server model and software release) minimum memory and disk size as described in the table below. For Cisco Unified Communications Manager 8.0(3) and above, it is strongly recommended to upgrade to minimum 4GB RAM and 146GB disk drive; whether this is necessary for your deployment is design-dependent and depends on call volume, installed locales, dial plans, phone firmware loads, music files, etc. Use http://www.cisco.com/go/swonly to get supported memory and disk part numbers.

Please rate helpful posts.


GP.

New Member

CCM upgrade from 6.1 to 8.6

Thank you guys for your support, i will try to do a trade in with Cisco if they will accept

Regards.

246
Views
10
Helpful
3
Replies
CreatePlease to create content