Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCM : Using E1 R2 with MGCP

Hi,

I cannot use my controller E1, with the gateway (MGCP) when i use the R2 signaling.

Have you any solution?

Rgds

1 REPLY
Hall of Fame Super Gold

Re: CCM : Using E1 R2 with MGCP

MGCP doesn't support E1 R2. So you have to use either H,323 or SIP.

Hope this helps, please rate post if it does!

772
Views
0
Helpful
1
Replies