Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCM4.2 & FXO problem

I have CCM4.2 connected over mgcp & E1 PRI to PSTN. Every thing woks fine, but I elso have 6 FXO ports, and try to configure 5 of them to connect to 5 another analog phone lines. And all that I have is disconnect signal...

This is configuration of one of 5 FXO ports:

voice-port 3/0/8

signal groundStart

dial-type pulse

cptone RU

timing hookflash-out 500

caller-id enable

Can any one help me?

136
Views
0
Helpful
0
Replies
CreatePlease login to create content