Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

VIP Super Bronze

CCM4.2 Intergration with Nortel Meridian Option 11

Guys,

Please I need assistance with this setup.

We have a 2811 that we are trying to configure as an MGCP gateway to interface a Cisco CCM into our Nortel Meridian PBX

Currently the E1 interface remains down, and in an alarm state

I will appreciate if ther is any documentation to use for this particular Nortel PBX for integration with CCM 4.2 using MGCP gateway..

VG: Cisco 2821, running IOS : c2800nm-advipservicesk9-mz.124-4.T2.bin

CCM ver 4.2

Nortel Meridian Option 11

Attached is the sh run on the router...

At the moment the e1

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
3 REPLIES
Hall of Fame Super Red

Re: CCM4.2 Intergration with Nortel Meridian Option 11

Hi Deji,

We tested using the following protocols, ESS5,NI2 and D100 (DMS-100).

The only one that has ever worked properly for us was DMS-100! .

Here are some great docs (have a close look at the White Paper);

Cisco Unified CallManager

Case Study: Nortel 61C PBX to Cisco IP Telephony Migration

From this good doc;

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_white_paper09186a00801115e0.shtml

Nortel Meridian PBX and Cisco CallManager Integration

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a008011888c.shtml

Hope this helps!

Rob

New Member

Re: CCM4.2 Intergration with Nortel Meridian Option 11

How about any docs in how to integrate a 2821 with a nortel 11c. In this case the 2821 will emulate network for the nortel.meaning that when nortel phones dial out to the pstn..they will go out to the pstn via a pri in the same 2821...also when an inbound call from the pstn needs to be routed to a nortel user, the did will come from the same pri at the 2821. Any configs will be greatly appreciated.

New Member

Re: CCM4.2 Intergration with Nortel Meridian Option 11

Hi

You mentioned E1 so i assume you are in europe, i have this setup with CCME working. The router config may help i at least know the basics here are correct.Ill also attach the pinouts for a cable to a dual PRI card.

BTW the T203 timer was crucial to getting the circuit up and running.

interface Serial0/0:15

no ip address

encapsulation hdlc

no logging event link-status

isdn switch-type primary-net5

isdn protocol-emulate network

isdn incoming-voice voice

isdn T203 30000

isdn negotiate-bchan

isdn outgoing ie display

isdn outgoing ie user-user

no cdp enable

regards

colin

157
Views
0
Helpful
3
Replies