Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CCM5.1 and Siemens - Seizing a trunk

Need to be able to use the paging system on a Siemens PBX. Siemens phones dial 6 then 8 digits. Is it possible to seize a trunk from an IP phone on CCM5.1 on a Siemens PBX? I know the access code (6)and have configured a Route Pattern of 6 and 6XXXXXXXX - no joy.

Any ideas?

Rich

2 REPLIES
Hall of Fame Super Gold

Re: CCM5.1 and Siemens - Seizing a trunk

How are you connecting to the PBX? Most likely you will need to look at debug isdn q931.

Community Member

Re: CCM5.1 and Siemens - Seizing a trunk

Its an MGCP GW connected to PBX via QSIG. The digits get to Siemens PBX but in one long string. Not sure if its possible to sieze the trunk by dialling 6 from an IP phone or if introducing a delay might help somehow?

261
Views
0
Helpful
2
Replies
CreatePlease to create content