CCM6.1 How can I setup a system wide external address book / SpeedDial List
I'm doing a CCM6.1 install and customer has requested that everyone has access to a system wide external address book and speed dials. Is this supported in CCM6.1, and if so how is it configured?
If not I assume that Cisco expect you to use web dialer - is that right?
In CCM4 I used to configure a CCM Operator User and use this for the external contacts list, and give each phone access to this address book via a service. In CCM6 the address books are all under the directories button now and there's no longer a service.
Re: CCM6.1 How can I setup a system wide external address book /
I will tell you what i've done. I used a translation pattern to translate to the full number. For example, dial *75 and four digit number. Created a spread sheet with these numbers and published it. This seemed to work well for my customers.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...