Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCM7 cluster

I have a 3 site cluster

site A has pub and sub1

site B sub2

site C sub3

All PSTN calls arrive at site A.

On the gateway for site A.

Should my dial-peer point to the Sub1 at site A. as the PUB is not doing call-processing?

or would it be better to point the site specific range at the relevant subscriber?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: CCM7 cluster

Yes, this is correct, any subscriber, as well as the publisher, can handle call processing.

Hope that helped, if so please rate.

3 REPLIES

Re: CCM7 cluster

Hello,

Just configure your dial-peers using the "preference" statement, and point each of them to a subscriber, and point the one with the lowest preference to the pub. This way, if any of the subs are down, calls can still be processed by another subscriber. See example:

dial-peer voice 1 voip

destination-pattern .T

session target ipv4: [sub1 IP]

dtmf-relay h245-alphanumeric

dial-peer voice 2 voip

destination-pattern .T

session target ipv4: [sub2 IP]

preference 1

dtmf-relay h245-alphanumeric

dial-peer voice 3 voip

destination-pattern .T

session target ipv4: [sub3 IP]

preference 2

dtmf-relay h245-alphanumeric

dial-peer voice 4 voip

destination-pattern .T

session target ipv4: [Pub IP]

preference 3

dtmf-relay h245-alphanumeric

Hope that helped, if so please rate.

New Member

Re: CCM7 cluster

many thanks,

so if for example a PSTN call comes in on the gateway at site A and it is destined for a DDI at site C, any subscriber can do the call setup. It doesn't have to be done by sub3 at site C.

Re: CCM7 cluster

Yes, this is correct, any subscriber, as well as the publisher, can handle call processing.

Hope that helped, if so please rate.

107
Views
0
Helpful
3
Replies