Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCME 4.0 on a 2811 interfacing with a Ericsson MD110

Currently have a 2811 running CCME 4.0 and would like to interface with an Ericsson MD110 using E1 QSIG. Does anyone have an example that I could start looking at.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: CCME 4.0 on a 2811 interfacing with a Ericsson MD110

This happens all the time.

Once you become familiar with the meaning of "debug isdn q931" you're able to adapt to almost any situation.

Please remember to rate useful posts with the scrollbox below!

3 REPLIES
Hall of Fame Super Gold

Re: CCME 4.0 on a 2811 interfacing with a Ericsson MD110

Just set switch type and you will be working. Then for additional features, see case by case.

Would be worth to update CCME because 4.0 is old already.

New Member

Re: CCME 4.0 on a 2811 interfacing with a Ericsson MD110

Thanks. I was trying to support some team members in a less perfect environment. My config was good but they were given incorrect telephone access #s and only partial E1 trunk access.

Hall of Fame Super Gold

Re: CCME 4.0 on a 2811 interfacing with a Ericsson MD110

This happens all the time.

Once you become familiar with the meaning of "debug isdn q931" you're able to adapt to almost any situation.

Please remember to rate useful posts with the scrollbox below!

140
Views
0
Helpful
3
Replies