I am configuring CCME with CUE on a 2801 series router with a 500 series switch to be used for IP phones and all other networked devices (very small site deployment). My data network is 192.168.1.0 and voice 192.168.2.0. I have a 1.0 address on the switch with the necessary voice and data vlans configured. My problem is that I can not get to the CUE GUI from a laptop with a 1.0 address. The 500 series is extremely limited. I have sub-interfaces configured on the router. I have tried every imaginable "smartport" configuration (including turning off CDP on the router interface to set the swithport as a "IP Phone and Desktop" smartport) to try to get inter-vlan routing to work. I am not able to ping the 2.0 interface or the CUE serivce-engine address from a laptop. I am able to ping the 2.0 interfaces from the switch to the router but only when the smartport is set for "router". Would anyone have any ideas on how I could get the inter-vlan routing to work with the 500 series?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.