Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCME and 7931 ip phone

I can't access to directory or any feature on 7931 ip phone. Does it need to configure something on CCME before this available. not problem with another ip phone like 7961

PBX:CCME 4.1

7931 Firmware:cmterm-7941_7961-sccp.8-2-2SR1.tar

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: CCME and 7931 ip phone

You are using the wrong firmware for a 7931, the firmware you posted is for 7941's and 7961's

Check this link

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_documentation_roadmap09186a0080189132.html

Under Specifications check out the firmware loads for the 7931 for the particular cme version (4.1) you are using.

The specified load is

SCCP31.8-2-2SR1S.loads

In addition the 7931's require you to create an ephone template and specify the button layout required for the 7931, otherwise you wont have access to the directories, menu, settings etc.

example

ephone-template 1

softkeys idle Newcall Gpickup Cfwdall Pickup Redial Dnd Login

button-layout 7931 2

Then apply it to the ephone

example

ephone 3

no multicast-moh

ephone-template 1

mac-address AAAA.BBBB.CCCC

type 7931

button 1:1

HTH

4 REPLIES
New Member

Re: CCME and 7931 ip phone

You are using the wrong firmware for a 7931, the firmware you posted is for 7941's and 7961's

Check this link

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_documentation_roadmap09186a0080189132.html

Under Specifications check out the firmware loads for the 7931 for the particular cme version (4.1) you are using.

The specified load is

SCCP31.8-2-2SR1S.loads

In addition the 7931's require you to create an ephone template and specify the button layout required for the 7931, otherwise you wont have access to the directories, menu, settings etc.

example

ephone-template 1

softkeys idle Newcall Gpickup Cfwdall Pickup Redial Dnd Login

button-layout 7931 2

Then apply it to the ephone

example

ephone 3

no multicast-moh

ephone-template 1

mac-address AAAA.BBBB.CCCC

type 7931

button 1:1

HTH

New Member

Re: CCME and 7931 ip phone

thanks for your help. It's a bad paste on my note. I use the good firmware but why i don't do is ephone-template. I'm going to try this solution, i give you feedback later

Many thanks

EB

New Member

Re: CCME and 7931 ip phone

In my case

When I answer a call from outside

Transfer button is inactive

Please Help

Hall of Fame Super Gold

Re: CCME and 7931 ip phone

Do you havesoftkey correctly configured in ephone-template ? And which IOS are you using ?

305
Views
0
Helpful
4
Replies
CreatePlease login to create content