Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CCME and Analogue phones

I have configured an analogue phone that is connected to an FXS port on the CCME router (2801) I have been able to register it as a SCCP phone and it is integrated with Voicemail. it all works fine except that when the analog phone is called from an internal IP Phone the analogue phone doesn't start ringing until after 3 rings. I can hear the ringing tone from the Ip Phone but nou until the 4th call progress can I hear the analogue ring. any Ideas?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: CCME and Analogue phones

Then I'm afraid the following applies to you:

http://cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800e372f.shtml

Try with an "import" phone.

Hope this helps, please rate post if it does!

3 REPLIES
Hall of Fame Super Gold

Re: CCME and Analogue phones

Are you in the uk? Is that an "official" bt phone ?

Community Member

Re: CCME and Analogue phones

Hi Paolo,

yes i am in UK and yes it is an actual bt phone

(Diverse 6350)

Hall of Fame Super Gold

Re: CCME and Analogue phones

Then I'm afraid the following applies to you:

http://cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800e372f.shtml

Try with an "import" phone.

Hope this helps, please rate post if it does!

101
Views
0
Helpful
3
Replies
CreatePlease to create content