I have several CCME sites migrating to Telco Voice Mail and have found an unusal issue.
When an inbound call comes into the FXO port the FXO Port and the phone ring on the first two rings, but on the third and fourth ring only the FXO port shows ringing.
Cisco 1861 Router
Voice Port Configuration
connection plar opx imediate 75669
The addion of imediate to the connection command allows the phone to ring without waiting for caller-id, if I remove this command the FXO port rings on the first two rings, then the phone rings on the third and fourth rings.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...