Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCME, ATA and Faxing

Hi,

I have Cisco Call Manager running on a 2800 series router and have a Cisco ATA-186 (SCCP firmware) that I wish to use for a couple of faxes. I've tried adding the following lines to my configuration however whilst a fax answers an incoming call it does not seem to be able to negotiate with the sending fax & obviously fails. I cannot send outgoing faxes at all. Config lines:-

ephone-dn 24 dual-line

number 2214

description fax1

call-forward busy 600

call-forward noan 600 timeout 15

ephone 24

mac address xxxx.xxxx.xxxx

type ata

button 1:24

The ATA is also configured Audio Mode 0x00150015

Any one any ideas?

Regards

2 REPLIES
New Member

Re: CCME, ATA and Faxing

I think you must configure the fax relay or something like this.

New Member

Re: CCME, ATA and Faxing

ATA is capable to work only with fax passthrough. As I remeber previously using CME ATAs for fax transmission was only able in H.323 mode. So you have to change load on your ATA to H.323 and try this way.

Look into:

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_configuration_example09186a00800d698e.shtml

Regards

Wojtek

207
Views
0
Helpful
2
Replies
CreatePlease to create content