1st, the port must be loop start. There is no ground start support in Italy.
2nd: with fxo ports, you never know what number has been called, it is not sent in signaling.
So you need "connection plar opx " under voice-port. usually you use a local extension number for that, like 2xx.
If you want to be able to direct calls depending on the number called, etc, get ISDN BRi with DID. ("selezione passante" or "multinumero"). Also with ISDN BRI you will have a lot of more features and stability.
Glad to know it works. If you have more ports, remember you can put the as "trunk group" and configure a single dial-peer. Plus for your convenience, below a dial-peer set for the italian mobile operators, that will allow only the numbers that are valid according to the prefix. The other advantage is that you can count calls made to each operator with "show dial-peer voice",
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...