Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CCME COR ISR

Hi,

I want to configure COR on a ISR router. I was hoping to block some phones to only allow them to dial internal phones only and possibly local calls.

I have been using http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a008019d649.shtml

but this only blocks toll free, etc.

I dont want to create multiple dial peers this if possible.

If any has any suggestions that would be great.

Thanks

2 REPLIES

Re: CCME COR ISR

hi friend,

may be you can apply this, for example:

dial-peer cor custom

name INTERNAL

name LOCAL

dial-peer corlist INTERNAL

member INTERNAL

dial-peer corlist LOCAL

member LOCAL

dial-peer corlist LOCAL_CALLS

member INTERNAL

member LOCAL

!-- for local calls

dial-peer voice 1 pots

destination-pattern [pattern]

!-- put this in "partition" LOCAL

corlist outgoing LOCAL

port [port]

...

ephone-dn 1 dualine

number 1000

!-- put this ephone in "partition" INTERNAL

corlist outgoing INTERNAL

!-- access to call ephones and local calls

corlist incoming LOCAL_CALLS

...

ephone-dn 2 dualine

number 1001

!-- put this ephone in "partition" INTERNAL

corlist outgoing INTERNAL

!-- access to only internal calls (ephones)

corlist incoming INTERNAL

...

Regards,

-- adrián.

Community Member

Re: CCME COR ISR

hi Adrian,

Thanks for this, didnt get a chance to test this yes as have been busy on other elements thatnks for the reply as this is what I was think but wanted to check

121
Views
0
Helpful
2
Replies
CreatePlease to create content