Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CCME Dial-peer voice "Outbound state is down"

Hi to all,

I have installed recently a CCME 4.0 on 2801 (ios is 12.4.9T).

I have a problem with the dial-peer, when I restart the CCME, or reset or change the dial-peer voice configuration, it go on "down", if I use command "sh dial-peer voice" or "summary" I see that the dial-peer on BRI interface are "Outbound state is down". It stay on this status until incoming call arrive, then it "Outbound state is up"! Why? Can you help me?

thank

Augusto.

  • IP Telephony
2 REPLIES
Silver

Re: CCME Dial-peer voice "Outbound state is down"

A problem has been seen when a translation profile is applied to an ephone-dn. No translational-profile applied to an ephone-DN.

Try:

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_guide_chapter09186a00804adaba.html

Re: CCME Dial-peer voice "Outbound state is down"

probably too late, anyway:

configure

"no dial-peer outbound status-check pots"

... and the peer is always up

/Martin

1420
Views
0
Helpful
2
Replies