Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCME FXO Call Waiting Hookflash

I have configured CCME 4 on a 2811. I am using a vic2-4fxo connected to the PSTN on the first 2 FXO ports. The ports are configured as follows:

voice-port 0/0/0

supervisory disconnect dualtone mid-call

timeouts call-disconnect 5

timeouts wait-release 5

timing hookflash-out 50

connection plar xxxxxxx

description xxx-xxx-xxxx

caller-id enable

!

voice-port 0/0/1

supervisory disconnect dualtone mid-call

timeouts call-disconnect 5

timeouts wait-release 5

timing hookflash-out 50

connection plar xxxxxxx

description xxx-xxx-xxxx

caller-id enable

I have also configured the FXO-Hookflash in my telephony-system setup parameters.

telephony-service

fxo hook-flash

In CCME 4.x call waiting is enabled by default. I have the "flash" softkey present on all phones during a call. When a second call comes in, I am presented with the call waiting "beep." However, when I press the "flash" softkey, the hookflash is essentially ignored and the call never flashes to the call-waiting.

Ideas, Suggestions?

Thanks in advance.

2 REPLIES
Hall of Fame Super Gold

Re: CCME FXO Call Waiting Hookflash

Hi,

50 msec hookflash sounds kind of short. Perhaps something like 150 or 200 should work. Also look at "debug vpm signal" to make sure sure hookflash is generated on key press.

New Member

Re: CCME FXO Call Waiting Hookflash

Thanks. Sometimes the obvious will get ya.

I increased the timing hookflash-out to 200 and the Call-Waiting works flawlessly now(anything below 200ms did not).

Thanks Paolo.

729
Views
5
Helpful
2
Replies
CreatePlease login to create content