Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CCME, FXO, voice hunt-group: caller-id issue

Hello,

I have C1861E-SRST router with c1861-advipservicesk9-mz.151-4.M2.bin and CCME 8.6.

PSTN is connected on FXO port.

Incomming call is forwarded to voice hunt-group (99) with 2 extensions on the list (91, 92). Both phones (SCCP) ring simultaneously, any of them can pick up the call. This works fine.

Caller-id is enabled on voice port.

The issue is, that caller-id displays only on the first extension from the hunt-group list (91). On the other phone "unknown number" appears on the display.

Here is the config:

voice hunt-group 9 parallel

list 91,92

pilot 99

voice-port 0/1/0
no battery-reversal
cptone SK
connection plar opx immediate 99
impedance complex2

caller-id enable
caller-id alerting ring 4

When I change the order of listed extensions to:

voice hunt-group 9 parallel

list 92,91

the caller-id displays on the 92 extension.

I need the caller-id to display on both phones. Is there a solution for this?

Thank you for the help.

Lubomir

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

CCME, FXO, voice hunt-group: caller-id issue

Have you tried using a shared DN instead?

That is more tested and reliable solution.

3 REPLIES
Hall of Fame Super Gold

CCME, FXO, voice hunt-group: caller-id issue

Have you tried using a shared DN instead?

That is more tested and reliable solution.

New Member

CCME, FXO, voice hunt-group: caller-id issue

Thank you, Paolo, it works this way.

Lubomir

Hall of Fame Super Gold

CCME, FXO, voice hunt-group: caller-id issue

Thanks for the nice rating and good luck!

520
Views
0
Helpful
3
Replies
CreatePlease to create content