Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCME Help needed please

Hi,

I have CCME 4.0 and it is currently using 4 lines (FXO modules) right now. We are looking at installing a PRI soon. I am having a problem with line selections as they are being held and not hanging up the call after completing. It takes about 4 sec to reset back to a normal hang up (line not busy). Also, 2 lines with caller ID is showing (external call)as the caller ID while the other 2 lines are showing the information.

1 REPLY
Silver

Re: CCME Help needed please

Could you please send through the following captures:

show ver

show diag

debug vpm signal (while making an inbound call)

debug voip ccapi inout (while making an inbound call)

http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b53c7.shtml

104
Views
0
Helpful
1
Replies