Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
182
Views
0
Helpful
1
Replies

CCME Help needed please

fragonzalez
Level 1
Level 1

‎05-13-2008 08:18 AM - edited ‎03-15-2019 10:37 AM

Hi,

I have CCME 4.0 and it is currently using 4 lines (FXO modules) right now. We are looking at installing a PRI soon. I am having a problem with line selections as they are being held and not hanging up the call after completing. It takes about 4 sec to reset back to a normal hang up (line not busy). Also, 2 lines with caller ID is showing (external call)as the caller ID while the other 2 lines are showing the information.

Labels:
0 Helpful
1 Reply 1

ivillegas
Level 6
Level 6

‎05-19-2008 06:14 AM

Could you please send through the following captures:

show ver

show diag

debug vpm signal (while making an inbound call)

debug voip ccapi inout (while making an inbound call)

http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b53c7.shtml

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents