Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCME Internal Dialing Question

First off, thanks in advance for helping out on this.  I know it should be easy but for some reason I cant figure it out.

I have set up a test CCME and everything is working just fine.  I have 2 phones and they are registered and all is well.  What I am trying to do is not make them call each other.  I would like to basically partition them so they can not dial each other.  I know this is easy in CallManager but I am having a difficult time in CCME.  My router is an old 1751-V running CCME 4.0(3).  I have tired ACL's and that only kills the RTP stream and I have also tried COR lists. Anybody have any ideas on how to make Phone 1 not call Phone 2?

I will post my config if needed.

Thanks,

Anthony

Everyone's tags (3)
1 REPLY
Hall of Fame Super Gold

Re: CCME Internal Dialing Question

There is more than one way.

Search "understand COR".

428
Views
0
Helpful
1
Replies