Hello to all I'm posting this thread to get some help om implementing Cisco CME through H323 with another vendor, in this case 3Com V3000. Here's the setup, I have 2 sites one with CME already working and another site (Site 2) with a 3Com NBX V3000 also using 3com's switches. 3Com states that it's Connextions software (H323 gateway) is capable of using g723.1 codec, but is not, since when I connect between them using transparent codec setup on the CME it works (cheapy but works) but when I configure g723r63 codec it connects to the gateway but no audio is heard.
Just to see if any other people have connected two systems like these ones. Any input will be appretiated.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...