Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCME & IP GSM

Hi every body, I need to integrate an CCME and a Gateway GSM of 2N. Some one ouf you have any information obout it.

The particular GSM Gateway is a Voice Blue Lite.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: CCME & IP GSM

You are welcome, please remember to rate useful posts with the scrollbox below.

7 REPLIES
Hall of Fame Super Gold

Re: CCME & IP GSM

Is that a SIP, BRI or analog unit ?

New Member

Re: CCME & IP GSM

I am trying to do it ovear a SIP trunk. It is the only protocol yhat the gateway GSM suport.

Hall of Fame Super Gold

Re: CCME & IP GSM

Just configure a voip DP with the appropriate destination-pattern, session-protocol sip, g711u an no vad.

For incoming, check what number the device is calling,you may need to translate it.

New Member

Re: CCME & IP GSM

In fact I did the configuration for the dial-peer and it have the characteristics that you coment but I can't see any SIP message betwen the CCME an the GSM Gateway.

I try using the TCP port 5060 and 5061 on the GSM Gateway. It works fine on a schema CUCM - GSM but is not working with CCME

Hall of Fame Super Gold

Re: CCME & IP GSM

Hi, please only use 5060 and UDP with CME.

Check that you have "session-protocol sipv2" else it does H.323 and you don;t see anything.

New Member

Re: CCME & IP GSM

A lot of thanks, the integration is working now. I'm using the default port onthe GSM Gateway (5060) and the mentioned parameters over the DP.

I'm just trying to give a fine tuning.

I will send you as atachment the final configuration to help futures menbers of this NetPro

Hall of Fame Super Gold

Re: CCME & IP GSM

You are welcome, please remember to rate useful posts with the scrollbox below.

185
Views
0
Helpful
7
Replies