Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CCME registration rejected

I cannot work out why I am getting the following error message

Name=SEP0013C3459F2F Load=8.0(5.0

) Last=Phone-Reg-Rej

I just cannot get a phone to register.

this is a known working config.

it picks up an ip add o.k

5 REPLIES
Hall of Fame Super Gold

Re: CCME registration rejected

What's your max-ephone and current number of registered ephones ?

Community Member

Re: CCME registration rejected

my max ephones are 10 and I have 7906 phones registered no problem. It is the 7940 that is refusing to register. I am using the reccomended firmware for ccme 4.2

Hall of Fame Super Gold

Re: CCME registration rejected

Try increasing max-ephone as there is no apparent reason for rejected registration.

Re: CCME registration rejected

Not sure if this is still an issue for anyone else, but I hit it face first tonight. I had set up the CME, and allowed it to auto configure the ephones as part of the telephony-service setup process. Increasing the max-ephone parameters didn't do anything.

My phones kept being rejected at registration. What was showing up in the config was this:

ephone 1

no multicast-moh

mac-address 0012.433D.D50F

keepalive 30 auxiliary 0

type 7940

button 1:1

I blew away ephone 1 and then rebooted the phone. This time it registered and came up. But the config now looks like this:

ephone 1

mac-address 0012.433D.D50F

type 7940

button 1:1

I went into the CLI and tried the other two commands that weren't there. Adding back in the no multicase-moh and rebooting the phone didn't cause any problems

But, it wasn't possible to add in the other command:

keepalive 30 auxiliary 0

IOS reports that the valid values for auxiliary are 1 - 65535

Apparently the setup utility creates an invalid value for this (which might have been legal under previous versions...I don't know).

I added in the command as:

keepalive 30 auxiliary 1

and the phone can register (although I'm not certain of the effect setting it this low).

Setting it to:

keepalive 30

also works.

Hope this helps someone else.

Cliff

Community Member

CCME registration rejected

Hi,

Just issue "ephone-reg" under telephony services.

Regards,

Loganathan S

CCNP (R&S)

3115
Views
0
Helpful
5
Replies
CreatePlease to create content