currently I can see that our CUCM pub is writing the CDR,s to our storage server at 4 hour intervals, 00:54 , 04:54 and 08:54 etc etc. However, I cannot understand where these are coming from at this interval as the daily scheduler states once at 01:00 and the CDR Load shows 00:00 every 24 hours??
Am I missing something here?
Where can I find the 4 hour schedule and how can I change it to a two hour interval....
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...