Hello, I'm just getting into Voice and trying to save Call Detail Records to the buffer of a 2800 series router running CME 8.6 with two 7940 ip phones.
I have CME set up and I'm placing a call and connecting between two extensions after following the book example to set CDR up.
Basically, the book example just shows the following commands:
logging buffered 512000
dial-control-mib retain-timer 10080
dial-control-mib max-size 700
Then, when I Place a call between two phones I have set up and answer the call. I check the logs(show logging) and no CDR info is logged like the pictures show. This is getting very frustrating but appears like it should be very easy to set up.
Is there more to the CDR configuration than the above? We're trying to track down who's been accidentally dialing 911 and I'm puzzled as to why CDR is not logging anything in the buffer when I try to test.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...