Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CEoIP PBX end to end loopback

I have 2x3845 with CEM E1 connecting to NEC PBX. the CEM circuit is up but i can't perform loopback test to the PBX to other PBX side.

I tried to use loopback network forn the E1 router controller, and i am getting nothing at the PBX site.

loopback local line from each Router to the PBX on the same site is OK.

Advice

Thanks & Regards

3 REPLIES
Hall of Fame Super Gold

Re: CEoIP PBX end to end loopback

Use an RJ45 loopback plug.

New Member

Re: CEoIP PBX end to end loopback

Hello,

I tried, but i can't get singnal/flash on the BPX on the other end.

I will move 1 router to the other site and i will connect both back-to-back, and then i will perform loopback.

hope it will work

New Member

Re: CEoIP PBX end to end loopback

Hi All,

How to check weather there is a traffic passing throuhg CEoIP circuit.

Any debug, or capture application?

Thnx

189
Views
0
Helpful
3
Replies