I am having trouble loading Cisco Emergency Responder 7.0 on a new IBM 3250 M2 server. Before purchasing these servers I emailed my config to TAC and they told me it was supported. Now if I try to install it tells me it can't find the driver for the DVD Drive and to manually select or load one. I opened another TAC case and they are now telling me that this server is not supported. Has anyone run into similar issues? Any thoughts Solutions? My entire server config is below:
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...