I have 15 buildings, each has in avarage 6 floors; each floor is devided in half; east and west wing. I have to creat about 120 different zones (ELIN). The most important part for me is to be able to put description in each port. Is there a way that I can bulk import the required info?
Every version of CER seems a little different on how it import/exports. id start by configuring one building or floor and then exporting it to CSV. Open in EXCEl and edit the port names you like. Import it back in. If this looks correct, this is your template. I have gone through and done this with Switchport Descriptions. Its a pain, but this is the only way you can add descriptions to switchports.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...