I have a overlapping dial plan problem. I have a CTI route point of 913XXXXXXXXXX and a PSAP of 913XXXXXXXXXX. This causes a problem with a route pattern. I would like to change this to 999XXXXXXXXXX at both the CTI route point and the PSAP. Please advise if this would cause issues with callback. Any help or comments will be appreciated. Thanks
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.