Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CER, RTT requirement between PUB and SUB

Hi,

I have two data centers and will be installed CUCM_PUB and CUCM_SUB in each location. and I want to install CER servers in each location as below combination but cannot find out CER requirement from CCO.

-data center1, CUCM_PUB, CER_PUB

-data center2, CUCM_SUB, CER_SUB

Q)

-can I install CER servers with the above combination?

-what is CER RTT (or something else) requirement between CER Publisher and Subscriber?

-CUCM RTT requirement is 80ms (after version 6.1). Is CER requirement belonging to CUCM?

***the CER subscriber requirement as per CER admin guide,

'Consider installing the standby server in a physically separate location from the primary server, and on a separate subnet not separated by a WAN link'

https://www.cisco.com/en/US/docs/voice_ip_comm/cer/7_0/english/administration/guide/e911plan.html#wp1045315

Advise plesae,

John

1 REPLY
Green

Re: CER, RTT requirement between PUB and SUB

Hi John,

There can be up to 40 msec RTT between a CUCM server and a CER server in a CoW

deployment.

This implies that there will be no more than 40 msec RTT between

CER publisher and CER subscriber as well.

If I remember correctly, the minimum bandwidth between CER publisher and

subscriber was the equivalent of a T1.

I'm not aware of any maximum delay or minimum bandwidth between CER servers in

different server groups.

330
Views
0
Helpful
1
Replies