I got a strange phenomenon at the moment, which I don`t understand.
Some weeks ago I did some changes, which may had some influence on this problem.
We´ve got to Sites with Communication Manager Express. When I make a Call forward for a DN from Site 1 to a Broadcast Hunt Group of Site 2 and try to reach that DN of Site 1 with a Phone on Site 1, no call get`s established.
Range of Numbers in Site 1: 300 - 399
Range of Numbers in Site 2: 100 - 199
Call from DN 100 (Site2) to DN 300 (Site1), DN 300 is busy and the call is forwarded to a Broadcast Huntgroup on Site 2 (for example: 199). The Phones on Site2 don`t ring and on the Calling phone (DN 100) you here nothing (no busy tone or anything else).
If I call from PSTN and not via WAN, the call gets established although DN 300 is forwarded to 199.
If I configure a sequentiell Huntgroup, the phones ring and the call is established when I call via WAN?! (This is the workaroundfor the moment)
Here are the Voip dial-peers:
dial-peer voice 2 voip
progress_ind setup enable 3
modem passthrough nse codec g711alaw
session target ipv4:172.16.100.3
incoming called-number .
voice-class codec 1
fax rate disable
fax protocol pass-through g711alaw
dial-peer voice 2000 voip
description ** cue voicemail pilot number **
translation-profile outgoing XFER_TO_VM_PROFILE
session protocol sipv2
session target ipv4:10.1.10.1
voice-class sip outbound-proxy ipv4:10.1.10.1
So the problem obviously just exisits, when I make a call to a busy DN of the other Site via WAN, which is forwarded to a BroadcastHuntgroup.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...