Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Change IP CUCM 6.1.5 no cluster with temporary license

Hello,

I have a CUCM6.1.5 (no cluster) with a temporay license, I need to change the address of the server urgently. After this ip change (couple of weeks), the CUCM will be upgraded to 7.1.5, then we will have a permanent license. Is there something special that I need to keep in mind or can I change the ip without any problems with the commands set network gateway and set network ip eth0

3 REPLIES
Green

Change IP CUCM 6.1.5 no cluster with temporary license

Hi,

Here is a link to changing IP address

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/install/6_1_2/ipchange/ipchg612.html

Remember to change any v/gateway config like dial peers, SIP trunks, MGCP etc etc

HTH

Alex

Please rate useful posts

Regards, Alex. Please rate useful posts.

Change IP CUCM 6.1.5 no cluster with temporary license

Make sure not to skip over any step on the document, otherwise the database may not start after the process and the server might need to be rebuilt.

New Member

Change IP CUCM 6.1.5 no cluster with temporary license

Thanks for the reply's, the change went smooth without any problem

382
Views
0
Helpful
3
Replies