We are implementing the integration of Nortel PBX with Cisco CUCM 8.6 using QSIG trunk.
When Nortel phone calls Cisco phones, if Cisco phone doesn't answer, the call gets forwarded to voicemail (Unity Connection 8.6), then Nortel PBX generates an error code saying it's unknown number/destination.
When Nortel phone calls the Auto Attendant number in Unity Connection, the Nortel PBX generates the same error code.
However, the regular calls from Nortel phone to Cisco phone, if Cisco phone answers (without going to Unity Connection), there is no error on Nortel PBX.
The issue seems to be whenever Nortel phones call into Unity Connection system, the Nortel PBX generates an error code saying unknown destination/number.
The technical support people for Nortel PBX is requesting me to check the D-channel programming to ensure that all messages are set up for integer and not octet. I don't know how I can change this on the Cisco voice gateway (QSIG trunk).
Anybody had same problem before or have any idea how to program Cisco voice gateway sending D channel IE using integer instead of octect? Is this doable on IOS?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...