Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Change to second dial-peer

I'm looking to have a call go to a second dial-peer after a set delay.

For example, I have dial-peer A and dial-peer B with the same destination-pattern.  I will put a higher preference on dial-peer A.  Call comes in and rings dial-peer A for 15 seconds.  No answer so call is redirected to dial-peer B.

Thanks in advance for any help

5 REPLIES
Cisco Employee

The preference command on the

The preference command on the dial-peers is for redundancy and when the call routes through dp A and fails, it will then route through dp B. However, in your case, the call reached the other end successfully using dp A and is now in the alerting state. Therefore, post this, even if the call is not answered, the router will not consider that to be a fail and route it out through dp B.

So unfortunately, your requirement can't be fulfilled using the preference command.

New Member

Sorry if I wasn't clear.  I

Sorry if I wasn't clear.  I knew that the preference command will not give me the result I was looking for, I was just saying I would use that to go to dp A first.  I was just hoping someone knew a way to go from an alerting state on dp A to dp B.

Cisco Employee

Ah ok. Unforunately, there

Ah ok. Unforunately, there isn't any way of achieving the move from dp A to dp B on alerting.

Cisco Employee

Not sure if TCL scripting

Not sure if TCL scripting might be able to do this, you can look into that.

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

OK, thank you gentlemen for

OK, thank you gentlemen for your time.  Looks like I'm going to need to find a different solution.

46
Views
0
Helpful
5
Replies