I have inherited a CME system that I'm not very familiar with and looking for some help. I have been asked to make international calling work on this phone system as apparently it never has before. After setting up an apprpriate dial-peer and consulting with the TELCO I've run into one last problem preventing this from working.
This is my dial peer:
dial-peer voice 40 pots
description *** Outbound International Dial Peer ***
Currently if I send all the digits for an international call, (ie. 01139XXXXXXXXXX) the call is tagged as an "International" call as per the Q931 debug below:
The TELCO has informed me that for this to work I must send the prefix 011 and have the call marked as "Unknown", OR send it without the 011 prefix and have it marked as "International". I've tried quite a lot of different things and just can't seem to get this to work.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.