Changing calling id / name for SIP URI calls to VCS
I have CUCM 9.1 clusted with a SIP trunk to a VCS-C. When making calls, the calls show a caller-id of extenstion@ip address, for exampe firstname.lastname@example.org. I have a directory URI setup on the phone that is generating the call, but it's now showing the URI. Inbound SIP URI calls are working fine.
Sorry I know this is an old post, but I think to resolve your issue you want to set the trunk destination to be the fqdn of the vcs-c. Simply changing from IP to FQDN actually makes the difference you're looking for. Just make sure you CUCM can query DNS. That will cover the domain portion of the caller-id being sent from CUCM to VCS.
Also under the outbound calls section of the trunk you then have the option to set the host portion of the caller-id to be DN or URI.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...