Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Changing time in Call Manager 6.0

The time displayed on our phones is 10 minutes ahead of the time displayed on the computers. I read that the device pool controls the time diplayed on the phones but was unable to change the time in the device pool associated with our phones.

3 REPLIES
New Member

Re: Changing time in Call Manager 6.0

Try syncing your CallManager to the same NTP source as the computers.

New Member

Re: Changing time in Call Manager 6.0

pcolbeck is right,

We resolved this by using our AD-Domain Controllers as our NTP source.

New Member

Re: Changing time in Call Manager 6.0

mpareja, I'm curious, how did you get your call manager to sync with your AD domain controller?

Each time I try setting our publisher to use our AD domain controller (using the IP) it says the NTP is not accessable. Curious if you had to do something further on your domain controller?

139
Views
0
Helpful
3
Replies