Can anyone provide guidance on connecting a VIC3-2FXS/DID module to a Bogen paging system ? We recently installed a Cisco VOIP/CM system , replacing a Nortel Norstar that was connected to a Bogen TPU60b amp via a ZPM3 , 3 zone paging module . The vendor that installed the Call Manager provided the VIC3-2FXS/DID and TMB2 but could offer no instructions on how to connect to the two devices together . I'm 1500 miles away from the site , need this info to send to a local vendor that knows ZERO about VOIP and paging systems . From what I gather , the DID port connects to the TMB2 which connects to the ZPM3 , the ZPM3 connects ( is already connected ) to the Bogen TPU60b amp . What is needed to connect the DID card to the TMB2 ?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...